Nanocrystalline or ferrite: choosing the shield for a thin wireless receiver

The shield behind a receiver coil guides the field and keeps it out of the battery. Nanocrystalline sheet does that job in a fraction of the thickness of ferrite.

A wireless charging receiver is more than a coil. Behind it sits a magnetic sheet that guides the field back to the coil, raises its inductance and shields the battery and electronics behind it. The choice of sheet sets most of the receiver's thickness.

Why nanocrystalline sheet is thinner

Iron-based nanocrystalline alloys saturate at around 1.2 T, compared with roughly 0.4–0.5 T for the Mn-Zn ferrites used in charging coils. Because each layer can carry more flux before it saturates, the same coupling needs far less material. Individual ribbons are only around 20 µm thick, so even a multi-layer laminate stays very thin.

Taming eddy currents

The alloy is a metal, so a continuous ribbon would carry eddy currents at charging frequencies and heat up. The laminated sheet is therefore fractured into small flakes before use. The flakes stay magnetically coupled but break the current paths, keeping losses in check.

When ferrite is still the better choice

Ferrite is inexpensive, has low losses and is easy to shape. Transmitter pads, larger coils and products with room to spare usually use ferrite. Our dual- and triple-coil transmitters, for example, sit on ferrite plates.

What to specify

  • Outline and number of layers of the sheet
  • Coil outer and inner diameter, inductance and test frequency
  • Total stack thickness, including adhesive
  • Lead exit position and length

Questions and answers

How thin can a receiver on nanocrystalline sheet be?
Our thinnest receivers with coil and nanocrystalline sheet are under 0.5 mm in total.
Why is the nanocrystalline sheet cracked?
Fracturing the laminated ribbon into small flakes interrupts eddy-current paths, which keeps losses and heating low at charging frequencies.
Nanocrystalline or ferrite: choosing the shield for a thin wireless receiver | Jinghong Technology